Pro Series HO Controller

V (Vintage) ALL Pro

The V (Vintage) ALL Pro is an HO Scale electronic controller featuring all the basics of the Pro Series controllers.  It is intended for use with All Vintage HO cars.  It features:

- 3 Range Sensitivity.  A 3 position switch offers three different ranges to maximize the Sensitivity adjustment.  The Middle switch position is intended for most Vintage cars.  It provides a range that is good for some Tjets, DASH, Johnny Lightning, Auto World and AFX/MT cars.  The Low (s) setting can be used to lower the Sensitivity range down for Tjets.  When running G-Plus, Super Magnatraction and some SS magnet cars the High (S) can be used.

- 100 ohm Adjustable Brakes to dial in just the right amount of Brakes.

- Adjustable Coast that is now set slower than the previous version. This new range provides better slow speed control where only a small amount of power is applied to the car. This amount of power start way below what is required to start a car moving or even keep it moving but it works well in providing just enough extra roll to counteracts strong magnetic downforce on magnet cars.   Since the Coast design is not resistor-based it does not use the Coast pot to dissipate heat.  All heat is contained inside the controller where it is safe to handle.  All 3 Pots on the ALL Pro will remain cool at all times (Assuming proper track connection).
Note: The previous version was designed with Auto-Pilot racers in mind. This is where the Coast power is used to navigate the turns and the racer pulls the triger on the straights. This is harder on the controller and usually not the preferred way to race. Since very few race this way any more we decided to change the range. If the old range is desired we can easily construct one with the old range.

This unique design allows the Coast and Sensitivity to be independent of each other.  Set the Coast and then set the Sensitivity WITHOUT having to go back and readjust the Coast.

The RED Brake wire does not have to be connected for Coast to function.

- Adjustable Choke to flatten out the response of the controller.  This allows the entire range of the trigger to be used in controlling the car vice just a small portion.  The Choke is fully bypassed at the full trigger pull.  The RED Brake wire does not have to be connected for Choke to function.














It is also available in a full HO range.  The HO range is for all HO cars. HO ALL Pro


V ALL Pro

Sensitivity - Fully CCW is the lowest sensitivity for the slowest starting speed in the selected range.  Fully CW is the highest sensitivity for the highest starting speed in the selected range.

Brakes - With the B/-/C switch in the B position, Fully CCW yields Maximum brakes, 0 ohms, while fully CW yields Minimum brakes, 100 ohms.  Minimum Brakes still provides some braking.  To remove all braking from the controller the RED Brake wire needs to be removed.

Coast - With the B/-/C switch in the C position, Fully CCW yields the Minimum Coast.  Fully CW yields the Maximum Coast.

Brake/Coast Selector Switch - With the Switch in the "B" position Brakes are selected.  In the "C" position Coast is selected.  With the Switch in the middle position neither Brakes nor Coast is selected.

Sensitivity Selector Switch - With the switch in the (s) position the Sensitivity knobs adjusts the lowest Sensitivity Range.   With the switch in the (S) position the highest Sensitivity Range is selected.   With the switch in the middle the middle and most useful range is selected.


Please check out the Controller Info at the bottom of the page.

$199.95

Select Your Controller Below

Pro Series HO ALL Pro V ALL Pro 32 ALL Pro HO Pro Lite V Pro Lite 32 Pro Lite


Selecting your Controller
What makes your Controller feel right?
What is Choke?
What is Coast?
Protection
Why does your fuse blow?
Connecting your Controller
Cleaning your Controller
Repair Services provided
Replacement Parts